Clifford SmartWindows 4 Uživatelský manuál stáhnout pdf (Strana 6)

Hood Trigger

Vehicles with a ground-switching hood light will interface directly with the Concept 100 (on positi ve switching Rolls-Royce vehicles, use a

relay to invert polarity). The switch may be located in or near the hood latch or at the hood light . If a switch cannot be located, you

must add a pin switch in a location away from water channels.

1.Connect the GRAY/YELLOW wire to the hood switch.

Final Wiring Connections

1. Connect the RED wire to the 5A fuseholder as shown on page 3.

2.Connect the RED/WHITE wire to the 20A fuseholder as shown on page 3.

3. Attach the two fuseholders to the battery positive cable clamp.

4. Attach the BLACK wire to the vehicle battery negative cable clamp.

NOTE: Power and test ac ces so ries af ter the ba sic sys tem has been tested. In di vidu ally fuse all ac ces sory power

con nec tions. In di vidu ally fuse all +12V con nec tions.

SmartPowerUp™ 2

SmartPowerUp 2 ensures that the system powers up in the same state (disarmed, armed or valet mode) it was last in. When you first power

up the system, it will silently enter its disarmed state.

Delayed Courtesy Lights

Some vehicles have a courtesy light delay or dimming circuit, which interferes with an alarm being able to detect the door trigger upon

remote arming. If the delay or dimming lasts more than 5 seconds, no special connections or testing are needed, simply turn on the Delayed

Courtesy Lights feature as noted in the Installer-Programmable Features section on page 10. Please note that since this feature sets the

system to arm the instant the courtesy lights are off, the Door Ajar Warning feature will not be av ailable.

Remote Control Channel Assignments

The Concept 100 comes with two ergonomically designed remote controls. Up to two additional Cliffo rd ACG 2 remote controls can

be added (older Clifford ACG and non-ACG remotes are not compatible with the Concept 100). For ins tructions on how to use the

remote controls, please refer to the Concept 100 User’s Manual.

Mas ter Re mote Control

6 Con cept 100/199

Func tion Press but ton(s)

Arm/Disarm

Activate Auxiliary A*

(usually remote trunk release)*

Silent Arm/Disarm

+ ✱

IntelliStart 4 or Other Wired Accessory*

✱

Activate Auxiliary B*

(such as timed headlight activation)

SmartWindows 4 Accessory*

Remote Valet Mode Enter/Exit*

+ ✱

Unassigned*

+ ✱

Unassigned*

*These channels can be assigned to control other Clifford ACG 2

systems and accessories on the customer’s other vehicles.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Komentáře k této Příručce

Žádné komentáře

Clifford SmartWindows 4 Uživatelský manuál Strana 6

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Clifford SmartWindows 4