Clifford SmartWindows 4 Instalační příručka stáhnout pdf (Strana 12)

www.directed.com

tips for adding smartwindows4 to systems

This section will assist when installing SmartWindows 4 with any of the following list-

ed systems. If doing so, it will be necessary to use the CliffNet Wizard Prosoftware.

AvantGuard 4

Concept 600

IntelliGuard 9000

or IntelliGuard Millennia

IIff uussiinngg SSmmaarrttWWiinnddoowwss44 WWIITTHH tthhee ssyysstteemm’’ss wwiinnddooww rroolllluupp eelleeccttrroonniiccss::

control the rear windows. When installation is complete:

1. Plug the Wizard cable into any available 3-pin DataPort connection in the instal-

lation (on SmartWindows 4, for example).

2. Launch the CliffNet Wizard PRO program.

3. Click the Install icon button at the top of the screen.

4. Turn ignition on and roll down all windows.

5. Make sure the check box next to the Program Windows button indicates

enabled, then click the Program Windows button. The rear windows (connected

to the built-in window roll-up electronics) will close.

6. Once the rear windows reach the top, wait 20 seconds, then click OK.

7. Click the Windows icon button at the top of the screen.

8. Click the Enter Program Mode button.

9. Hold one of the front window switches “up” for about 2 seconds, then release

(the switch must be connected to SmartWindows 4). The window should move

immediately when you hit the switch.

10. Allow the windows to finish the programming cycle. This should take about 2

minutes and is indicated as complete when both windows vent slightly.

a. If you have another SmartWindows 4 to program, select ID2 from scroll

bar at top and repeat steps 7-10.

1 2 ... 7 8 9 10 11 12 13 14 15

Žádné komentáře

Clifford SmartWindows 4 Instalační příručka Strana 12